3Ware 9650SE8ML 8 Port Multi Lane Serial ATA II PCI-Express 8X RAID Card
| Model |
9650SE-8LPML |
| Form
Factor |
Low Profile |
| Port
Count |
8 |
| PCI
Express Lanes |
4
|
| Raid
Levels |
0,1,5,6,10,50,Single Disk,JBOD |
| Onboard
Memory |
256 MB
DDR2 533 |
| Connector
Type |
Multi-lane |
| BBU
Support |
Yes |
3ware 9650SE Features
- 8th-generation StorSwitch™ non-blocking switched
architecture.
- On-board I/O RISC processor and RAID offload provides
true hardware RAID.
- SCSI device driver model to take advantage of the benefits
of SCSI using inexpensive Serial ATA drives .
- Bootable array support for greater fault tolerance.
- Variable stripe size for performance tuning by
application.
- 64-bit LBA support.
- ATA pass-through mode support.
- Up to 512MB DDR2 533 memory with ECC protection. (see
table below)
- 32 pooled DMA channels.
- Complete configuration management suite.
- 3ware BIOS Manager 2 (3BM2) – easy to use BIOS
configuration tool.
- 3ware Disk Manager 2 (3DM®2) – browser-based management
tool.
- Command Line Interface (CLI) – scriptable configuration
tool.
- SNMP support.
- SMTP support for email/pager notification.
- ATA/6 and Out of band (OOB) staggered drive spin-up
support.
- Auto carving allows LUNs > 2TB to be divided into
multiple units for legacy operating systems limited to 2TB
max. per LUN.
- Battery Backup Unit (BBU) support.
- Multiple logical unit sizes and RAID levels on one card.
- Multiple card support within a system for large storage
requirements.
- Hot-swap and hot-spare support for data availability.
- Dynamic sector repair for robust data protection.
- S.M.A.R.T. disk drive monitoring for reliability.
- Emergency Flash Recovery protects against failed
firmware upgrade.
- Drive activity LED support.
- Online Capacity Expansion and RAID Level Migration.
- Enhanced data protection with write journaling for
non-redundant arrays and accidental drive removal.
- Drive insertion and removal notification.
- Array/Drive Status and drive identification LED support.
(requires 3ware Chassis Control Unit-enabled backplane)
- Chassis Control Unit for enclosure management via I2C.
|
|
